Appendix; Specifications - Fuji Electric CC-M Instruction Manual

12. APPENDIX

12.1 SPECIFICATIONS

1. Control and computation functions
Control and computation functions are implemented by combining function-software packages
called "wafers." Combination of wafers is called "wafer connection."
CC-M comprises 100 kinds of wafers.
Wafer connection is made by operating the keys on the front panel or using the special
configurator.
(1) PID control
• Number of loops
• Proportional band (P)
• Integration time (I)
• Derivative time (D)
(2) Programming function
• Programming method
• Program capacity
• Kind of wafer
(3) Computation cycle
(4) Alarm function
• Method
• Kinds
2. Input signals
Performance under reference condition(23±2˚C, 55±10%RH, Power voltage and frequency
50/60 Hz)
2-1 Analog input signal
• Number of inputs
INP-TN1PDA3-E
: Selected according to type designation from the following.
1 loop (1 control output)
2 loops (2 control outputs)
4 loops (4 control outputs)
: 1.0 to 3276.7%, set at 3000.0% for delivery
: 0.1 to 3276.7 sec, set at 3000.0 sec for delivery
: 0.0 to 900.0 sec, set at 0.0 sec for delivery
: Wafer connection method
Select whether wafer connection is to be made by user or at the
factory according to the designation
: 48 wafers × 4 loops (max. 192 wafers)
A maximum of 48 wafers usable in 1 loop
: 100 kinds listed in Table 1
: 200 ms for 4-loop (8PID) control of simplicity PID
: Alarm can be displayed and output through wafer connection.
: Each high/low of PV, SV and MV, PV change rate alarm, MV
change rate alarm, high/low deviations.
: 8 inputs
12 - 1