Advertisement
Attaching the Mounting Bracket to a Ceiling
Objective
Mounting Bracket Hole
Locations
DEC 2000
SC 300 BTS Hardware Installation, ATP and FRU Procedures
The objective of this procedure is to attach the adapter and mounting
bracket to a ceiling.
IMPORTANT
*
You can only mount the Picocell to a ceiling.
Due to the many types of ceilings that the BTS may be mounted to, it is
impossible to detail all types in the context of this manual. For this
reason, the installers must use good judgement and get recommendations
from qualified personnel regarding the type of mounting bolts that are
appropriate for the particular ceiling mount for the BTS.
CAUTION
For all applications always consult a licensed Civil
Engineer to determine the exact (Zone 3 and/or Zone 4)
compliance of your specific site.
CAUTION
The top surface of the ceiling adapter must be mounted
horizontally. The bubble level indicator in the center of the
bracket must have the bubble in the center of the inner
black circle after mounting the adapter. Failure to do so
could cause damage to the unit and would void the
warranty.
The ceiling adapter has been provided with multiple mounting options
dependent on special site requirements. Specific holes to complete the
installation are site specific. They are to be provided by site installation
teams in accordance with a Civil Engineer to determine the exact
compliance for your specific site. The ceiling mounting bracket is
provided for correct installation angle only. Figure 3-1 shows some of
the holes that can be used to attach the adapter to the ceiling.
PRELIMINARY
3
3-9
Advertisement
Chapters
