Attaching Back Solar Cover To Mounting Bracket; Table 3-10: Procedure To Attach Back Solar Cover To Mounting Bracket; Objective; When To Use The Cover - Motorola SC 300 Manual

Attaching Back Solar Cover to Mounting Bracket

Objective

When to Use the Cover

Required tools

Procedure

DEC 2000
SC 300 BTS Hardware Installation, ATP and FRU Procedures
The objective of this procedure is to attach the back solar cover to the
mounting bracket.
Solar Covers are required in all outdoor applications
The following tools are required to attach the back solar cover to the
mounting bracket.
Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M
T30 Torx bit
Attach the back solar cover to the mounting bracket by following the
procedure in Table 3-10 and the information in Figure 3-8.
Table 3-10: Procedure to attach Back Solar Cover to Mounting
Step
1 Place the back solar cover on the mounting bracket so the
cooling vents are at the top. Align the four M6 screws with
the mounting holes.
2 Using a T30 Torx bit, start but do not tighten all four M6
screws.
3 Using the T30 Torx bit, tighten the four M6 screws to 5.0
N–m.
Bracket
Action
PRELIMINARY
3
3-19