Lubricants, Fuel, And Coolant Table - Kubota BX1880-AU Operator's Manual

LUBRICANTS, FUEL, AND COOLANT TABLE

LUBRICANTS, FUEL, AND COOLANT TABLE
No. Locations
1 Fuel
2 Coolant with recovery tank
3 Engine crankcase
4 Transmission case
5 Front axle case
Greasing
Battery terminal
Speed control pedal
6
Rear link
Hood lock
Hood guide
*1 Oil amount when the oil level is at the upper level of the oil level gauge.
*2 The product name of KUBOTA genuine UDT fluid may be different from that in the operator's manual depending on countries or territories.
Consult your local KUBOTA Dealer for further detail.
Fuel
• Cetane number of 45 is minimum. Cetane number greater than 50 is preferred, especially for the following
temperatures or the following elevations.
Temperatures
Elevations
Fuel used
• Diesel fuels specified to EN 590 or ASTM D975 are recommended.
• No.2-D is a distillate fuel of lower volatility for engines in industrial and heavy mobile service (SAE J313 JUN87).
• Higher sulfur fuel may be allowed to use than the one specified in the preceding table. Consult your local
KUBOTA Dealer for further detail.
Engine oil
• Oil used in the engine should have an American Petroleum Institute (API) service classification and proper SAE
engine oil according to the ambient temperatures as shown in the preceding table.
• See the following table for the suitable API classification engine oil according to the engine type with internal
EGR, external EGR, or non-EGR, and the fuel.
Oil class of engines except external EGR
CF, CF-4, CG-4, CH-4, or CI-4
EGR
Exhaust gas re-circulation
• The CJ-4 engine oil is intended for DPF (diesel-particulate-filter) type engines, and cannot be used on this tractor.
BX1880, BX2380, BX2680
Capacities
BX1880 BX2380
25 L
(6.6 U.S.gals.)
2.9 L 3.1 L
(3.1 U.S.qts.) (3.3 U.S.qts.)
*1 *1
3.0 L 3.3 L
(3.2 U.S.qts.) (3.5 U.S.qts.)
11.3 L
(3.0 U.S.gals.)
3.6 L
(3.8 U.S.qts.)
No. of greasing points
2
1
4
1
1
Below -20 ℃ (-4 ℉)
Above 1500 m (5000 ft)
Ultra low sulfur fuel [<0.0015% (15 ppm)]
Engine oil classification (API classification)
BX2680
No. 2-D diesel fuel
No. 1-D diesel fuel if temperature is below
-10 ℃ (14 ℉)
3.3 L
Fresh clean soft water with antifreeze
(3.5 U.S.qts.)
• Engine oil
API Service Classification CF or higher
Above 25 ℃ (77 ℉)
*1
4.0 L
(4.2 U.S.qts.)
-10 ℃ to 25 ℃
(14 ℉ to 77 ℉)
Below -10 ℃ (14 ℉)
• KUBOTA SUPER UDT-2 fluid
• KUBOTA SUPER UDT-2 fluid
oil
Capacity
moderate amount
until grease overflow
moderate amount
moderate amount
moderate amount
Oil class of engines with external EGR
CF, or CI-4
You cannot use the class CF-4, CG-4, and CH-4 engine oils on ERG-
type-engines.
MAINTENANCE
Grade
SAE30, SAE10W-30 or 15W-40
SAE20, SAE10W-30, or 15W-40
SAE10W-30
*2
*2
or SAE 80-SAE90 gear
Type of grease
Multipurpose
EP2 Grease (NLGI Grade No.2)
73