Replacing The Fuel Filter Element; Service Every 800 Hours; Adjusting The Engine Valve Clearance; Service Every 1000 Hours Or 1 Year - Kubota BX1880-AU Operator's Manual

PERIODIC SERVICE
4. After draining the front-axle-case-oil, reinstall the
drain plugs.
5. Remove the right and left breather plugs.
6. Fill with new front-axle-case-oil up to the upper
notch on the dipstick.
(See LUBRICANTS, FUEL, AND COOLANT TABLE
on page 73)
IMPORTANT :
• After the following minutes, check the front-
axle-case-oil level again. If the front-axle-
case-oil level is lower than the prescribed
level shown in the following figure, add the
front-axle-case-oil to prescribed level.
Checking the front axle case oil level
7. After filling with front-axle-case-oil, reinstall the oil
gauge and breather plugs.
(1) Breather plug
(2) Oil gauge with dipstick
(3) Drain plug

5. Replacing the fuel filter element

• Consult your local KUBOTA Dealer for replacing the
fuel filter element.

SERVICE EVERY 800 HOURS

1. Adjusting the engine valve
clearance
• Consult your local KUBOTA Dealer for adjusting the
clearance of the engine valve.
92
10 minutes after filling with
new front axle case oil
(A) Front axle case oil level is
acceptable within this range
SERVICE EVERY 400 HOURS
SERVICE EVERY 1000 HOURS
OR 1 YEAR
1. Replacing of the air cleaner
element
Replace the air cleaner element every 1000 hours or
every 1 year whichever comes faster.
(See 2. Cleaning the air cleaner element on page

SERVICE EVERY 1500 HOURS

1. Checking the injection pressure of
the fuel injection nozzle
• Consult your local KUBOTA Dealer for checking the
injection pressure of the fuel injection nozzle.
SERVICE EVERY 2000 HOURS
OR 2 YEAR
1. Flushing the cooling system and
changing the coolant
WARNING
To avoid serious injury or death:
• Do not remove the radiator cap while the
coolant is hot. When the coolant is cool, slowly
rotate the radiator cap to the first stop and allow
sufficient time for excess pressure to escape
before removing the radiator cap completely.
IMPORTANT :
• Do not start the engine without coolant.
• Use clean, fresh soft water and the antifreeze to
fill the radiator and the recovery tank.
• When mixing the antifreeze with water, the
antifreeze mixing
percentage.
Antifreeze mixing ratio with water
• Securely tighten the radiator cap. If the radiator
cap is loose or improperly fitted, water may leak
out and the engine could overheat.
Be sure to flush the cooling system and to change the
coolant once every 2000 hours or every 2 years
whichever comes faster.
85)
ratio is the following
50%
BX1880, BX2380, BX2680