Checking The Engine Start System; Checking The Opc (Operator Presence Control) System - Kubota BX1880-AU Operator's Manual

PERIODIC SERVICE
(1) Grease fitting for the speed
control pedal
(2) Battery terminals
Apply grease between stays.
(1) Hood lock

2. Checking the engine start system

WARNING
To avoid serious injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
82
(3) Hood guide
(4) Rear link
Preparation before testing
1. Sit on the operator's seat.
2. Set the parking brake and stop the engine.
3. Shift the range-gear-shift-lever to the neutral [N]
position.
4. Check whether the speed-control-pedal is in the
neutral position.
5. Shift the PTO-clutch-lever to the off
Test of switch for the speed control pedal
1. Make sure that the range-gear-shift-lever is set in
the neutral [N] position.
2. Depress the speed-control-pedal.
3. Turn the key to the start
4. Make sure that the engine does not crank.
5. If the engine cranks, consult your local KUBOTA
Dealer.
Test of switch for the PTO clutch lever
1. Make sure that the range-gear-shift-lever is set in
the neutral [N] position.
2. Make sure that the speed-control-pedal is set in the
neutral position.
3. Shift the PTO-clutch-lever to the on
4. Turn the key to the start
5. Make sure that the engine does not crank.
6. If the engine cranks, consult your local KUBOTA
Dealer.
(1) Range gear shift lever (Hi-
Lo)
3. Checking the OPC (operator
presence control) system
WARNING
To avoid serious injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
Preparation before testing
1. Sit on the operator's seat.
SERVICE EVERY 50 HOURS
position.
position.
position.
position.
(2) PTO clutch lever
(3) Speed control pedal
BX1880, BX2380, BX2680