Table of Contents
Advertisement
PERIODIC SERVICE
4. Front distance should be the length as shown in the
following table. If front distance is not proper length,
adjust the length of the tie rod.
(To adjust the tie rod, see
on page
90)
0 mm to 5 mm (0 in. to 0.2 in.) less than
Front distance
rear distance
(A) Wheel-to-wheel distance at
rear
(B) Wheel-to-wheel distance at
front
4.1 Adjusting the toe-in
1. Loosen the lock nut and turn the tie rod to adjust
the rod length until the proper toe-in measurement
is obtained.
0 mm to 5 mm (0 in. to 0.2 in.) less than
Front distance
rear distance
2. Retighten the lock nut.
(1) Lock nuts
90
4.1 Adjusting the toe-in
(C) Front
(2) Tie-rod
SERVICE EVERY 200 HOURS
SERVICE EVERY 400 HOURS
1. Adjusting the front axle pivot
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key
before adjusting the front axle pivot.
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the
steering wheel.
1. Remove the split pin and tighten the adjusting nut.
Tightening torque
2. Make sure that one of the nut slots aligns with the
split pin hole.
3. Tighten the nut slightly if necessary when aligning
the nut slots with the split pin hole.
4. Replace the split pin.
(1) Adjusting nut
2. Changing the transmission fluid
WARNING
To avoid serious injury or death:
• Oil can be hot and can burn. Allow the engine to
cool down sufficiently.
Transmission fluid
Transmission fluid capacity
1. To drain the used transmission fluid, remove the
drain plug at the bottom of the transmission case
and drain the transmission fluid completely into the
oil pan.
20 N⋅m
(2.0 kgf⋅m)
(15 lbf⋅ft)
(2) Split pin
KUBOTA SUPER UDT 2
11.3 L
(3.0 U.S.gals.)
BX1880, BX2380, BX2680
Advertisement
Table of Contents
