Table of Contents
Advertisement
4. INSTALLING MANUAL
4.1.
Desktop use
NTAG I²C plus Explorer Kit OM5569/NT322E consists from Connected Tags Explorer Board
OM5569 with NTAG I
It is intended for development use in development environment such are development
departements in factories, at institutes, etc. It demonstrates the unique properties of the
NTAG I²C tag chip.
External power supply is not required (only for LCD backlight – but it is not necessary for
operating Connected Tags Explorer Board).
Firmware is already written in LPC11U24 microcontroller and no extra programming via
JTAG interface is needed. A NFC mobile phone is needed for demonstration (an application
for mobile phone is avaliable on Android market). User can write his own application and
write it via JTAG interface into microcontroller.
4.2.
Power supply
Connected Tags Explorer Board with NTAG I²C plus Anttena Board is powered via RF field
from NFC mobile phone (13,56 MHz). It is no need for external power supply or battery (only
for LCD backlight - but it is not necessary for operating NTAG I²C Explorer Board).
NTAG I²C tag ic on NTAG I²C plus Antenna Board provides up to 2V with 5 mA current
output (typical) on Vout pin. This is enough to power low power microcontroller LPC11U24,
LCD display, temperature sensor and LED.
Note 1:
Power supply from USB port on personal computer has to comply with LPS requirement of
IEC60950-1.
Maximum lenght for USB cable is 3 meter.
SRSt Template 1.0
Doc ID: DOC-XXXXXX
BL ID
C plus Antenna Board OM5569/NT322E 54 x 27 mm.
2
Project Name: Integration Manual Project ID: 62743
public
Doc Rev 1.00 Approved — 2015.09.01
Hardware Manual
© NXP B.V. 2015. All rights reserved
13 of 18
Advertisement
Table of Contents
