Connecting To Your Network; Cable Type & Length; Cabling - Lantronix Xpress-Pro SW 52000 User Manual

Connecting to Your Network

Cable Type & Length
It is necessary to follow the cable specifications below when connecting the switch to
your network. Use appropriate cables that meet your speed and cabling requirements.
Speed Connector
10BaseT RJ-45
100BaseTX RJ-45
100BaseFX SC, ST
100BaseFX SC, ST

Cabling

1. First, ensure the power of the switch and end devices is turned off.
2. Always ensure that the power is off before any installation.
3. Prepare cable with corresponding connectors for each type of port in use.
4. To connect two regular RJ-45 ports between switches or hubs, you need a cross-
over cable.
5. Consult the previous section for cabling requirements based on connectors and
speed.
6. Connect one end of the cable to the switch and the other end to a desired device.
Once the connections between two end devices are made successfully, turn on the
power and the switch is operational.
XPress-Pro SW 52000 User Guide
Port Speed Cable
Half/Full Duplex
10/20 Mbps 2-pair UTP/STP Cat. 3, 4, 5
100/200 Mbps 2-pair UTP/STP Cat. 5
100/200 Mbps MMF (50 or 62.5µm)
100/200 Mbps SMF (9 or 10µm)
3: Installation
Max.
Distance
100 m
100 m
2 km
15, 40, or 75 km
11