Vector; Transparency; Peaking Filter - Datavideo TLM-170K Instruction Manual

is close to one of those boxes, then that means that color in the image is very saturated.
Intersecting lines: The line going up towards the yellow and red colors is the skin tone line on
which the skin color should fall regardless of the person's race.
Waveform Monitoring
Waveform monitoring consists of RGB and YCbCr waveforms which are used to measure the
brightness, luminance and chroma of a video signal as shown in the diagram below.
Waveform monitoring not only warns the user of out-of-range conditions such as overexposure but
also serves as a good tool for color correction and white and black balance.

Vector

This enables/disables the vector scope.

Transparency

This selects the transparency of the waveform and vector scope.
 50% blend effect
 25% blend effect
 Off: Opaque

Peaking filter

The peaking filter, once enabled, will place color lines on edges of the subject of the focus in the
image. This function works well if the subject of the focus is correctly exposed for high contrast.
Red, Green, Blue, White and Black are the five available outline colors on the TLM-170K.
The Peaking Level determines the sensitivity of the filter. Setting the peaking level to a high value
means more areas will be highlighted including lower contrast areas. If the peaking level is set to a
low value, then only areas of high contrast will be highlighted.
The diagram below illustrates images with peaking filter applied to the subject of the focus. Note
the different colors of the outline in each picture.
25