Getting Started
Connect External Power Supply to the MX3P
The DC power jack is located on the endcap. The passive cradle does not have a power jack.
1. Insert the barrel connector into the power jack on the mobile device endcap and push in
2. The CHGR LED above the keypad illuminates when the MX3P is receiving external
See section titled "LED Functions" for explanations of the LEDs for the BATT B and BATT M
illuminations.
MX3P Specific Power Accessories
Part Number
9000A060CBL12V
9000A316PS24V72VMX3P
24/72 Maximum VDC MX3P Power Supply Input/Output Cable
Connection
Caution
LXE Part Number: 9000A316PS24V72VMX3P
Figure 1-13 Vehicle Power Supply, 24 – 72 Maximum VDC (Fuse Not Shown)
E-EQ-MX3XRG-L
Figure 1-12 Connect External Power Supply
firmly.
power through the power jack.
For proper and safe installation, the input power cable must be connected to a fused
circuit on the vehicle. This fused circuit requires a 5 Amp maximum time delay (slow
blow) fuse. If the supply connection is made directly to the battery, the fuse should be
installed in the positive lead within 5 inches of the battery positive (+) terminal.
Recommended for vehicle electrical systems that use between 2 and 5 twelve volt
batteries in series.
Description
POWER CABLE, BARE WIRE, 12 FT, 12V, DC JACK
PS, 24V-72V, BARE WIRE INPUT, MX3P OUTPUT
1. Power Switch
2. Power On Indicator
3. Output to MX3P
4. Input from Vehicle Battery
13
MX3X Reference Guide