STEP 9.
Tighten the terminal cover.
Step 10.
a) Connect the Y-Cable to the Measuring.
b) Cell and to the Vortex Flow Meter.
8.3.2 Typical Piping Installation
Option 1.
The flow direction is from left to right.
For the piping, remove the previous fittings
and mount the delivered fittings 1/4" 6 mm
OD.
Connect to the
Measuring Cell
Option 2.
The flow direction is bottom-up. Make
sure that the flow laminator pipe
should not be bent about 100mm to
the Flow Sensor.
The bent flow laminator pipe is not delivered by DECKMA
HAMBURG.
Page: 46
Connect to the
Vortex Flow Meter