Installation; Electrical Installation Step-By-Step - Deckma Hamburg OMD-24 Series Instruction Manual

8.3

Installation

The Conversion-Kit to OMD-24 FC should be located as shown in section 8.2
Construction. The Vortex Flow Sensor can be installed in two different ways. It is
recommended to use either Option 1. or Option 2.

8.3.1 Electrical Installation Step-By-Step

 See Section 2.
STEP 1.
Unscrew the terminal cover.
STEP 2.
a) Unscrew the PE-Cable from the terminal
cover.
b) Remove the connection cable from the
PCB.
c) Unscrew in countered the connection
cable from computer box.
STEP 3.
a) Put the spring washer onto the screw of
the terminal cover.
b) Put the ring washer onto the screw of
the terminal cover.
c) Put the PE-Cable onto the screw of the
terminal cover.
d) Tight in the nut.
e) Insert the Y-Cable through the terminal
compartment und screw it.
Important Notes concerning installation.
Page: 44
a
b
d
c
a
b
c
e