General Information For Configuring Ethernet - Endress+Hauser SpectraSensors SS2100 Operator's Manual

connect to any others. If this connection fails, the unit
continues to scroll through the table until it connects to
another IP in the host list.
The host list is disabled for Manual Mode and for Modem
Mode. The unit will not accept a data connection from a
remote device when the host list option is enabled.
– LED: Select Blink for the status LEDs to blink upon
connection or None for no LED output.
•
Disconnect Mode
– On Mdm_Ctrl_In Drop: Set to Yes for the network
connection to or from the serial port to disconnect (drop)
when Modem Control In transitions from an asserted state
to not asserted state. The default setting is No.
– Hard Disconnect: When set to Yes, the TCP connection
closes even if the remote site does not acknowledge the
disconnect request.
– Check EOT (Ctrl-D): Select Yes to drop the connection
when Ctrl-D or Hex 04 is detected. Both Telnet Com Port
Cntrl and Check EOT (Ctrl-D) must be enabled for
Disconnect with EOT to function properly. Ctrl-D is only
detected going from the serial port to the network. The
default setting is No.
– Inactivity Timeout: Use this parameter to set an inactivity
timeout. The unit drops the connection if there is no activity
on the serial line before the set time expires. Enter time in
the format "mm:ss", where "m" is the number of minutes and
"s" is the number of seconds. To disable the inactivity
timeout, enter 00:00.
3. When finished, click the OK button.

General Information for Configuring Ethernet

For more information on configuring your computer for Ethernet connection,
please refer to the Lantronix website below.
•
https://www.lantronix.com/products/xport-direct/#docs-downloads
Operator's Manual
Ethernet Communications
–
4 9