Table of Contents
Advertisement
Available languages
Available languages
INSTRUCTION MANUAL REGARDING USE AND MAINTENANCE
PART 1
TO BE KEPT BY THE USER
1. INTRODUCTION
This instruction manual is made up of two parts: PART 1 which contains general
information regarding all our production and PART 2 which contains specific
information regarding the motor-driven pump that you have purchased. The
EN
two booklets are complementary to each other, therefore make sure that you
have both of them. Follow the instructions given in these booklets in order to
obtain optimum return and operation from your motor-driven pump. If any other
information is necessary, please contact the nearest authorised retailer. If the
booklets contain contrasting information, keep to what is indicated in PART 2
(product specifications).
THE REPRODUCTION, EVEN PARTIAL, OF THE ILLUSTRATIONS AND/
OR TEXT HEREIN IS FORBIDDEN.
The following symbols are used throughout the instruction booklets:
WARNING!
Risk of damaging the pump or the system
Risk of injuring people or damaging things
Risks of an electrical nature
2. CONTENTS
1.
INTRODUCTION
2.
CONTENTS
3.
4.
5.
6.
7.
INSTALLATION, DISMANTLING AND TRANSPORTATION
8.
9.
13. DECLARATION OF CONFORMITY
3. MANUFACTURER IDENTIFICATION DATA
3.1. MANUFACTURER DATA
EBARA PUMPS EUROPE S.p.A.
Registered office:
Via Campo Sportivo, 30 - 38023 CLES (TN) ITALY
Telephone: 0463/660411 - Telefax: 0463/422782
Assistance Service:
e-mail: tcs.epe@ebara.com
Tel. +39 0444 706968
3.2. MOTOR-DRIVEN PUMPS
See plates
in FIG. 6:
For product type, see PART 2.
4. GUARANTEE AND TECHNICAL ASSISTANCE
THE GUARANTEE IS RENDERED NULL AND VOID IF THE INSTRUCTIONS
GIVEN IN THIS BOOKLET ARE NOT ADHERED TO AND/OR IF ANYONE
OTHER THAN PERSONNEL FROM OUR HELP CENTRES INTERVENES
8
6.1 for motor-driven surface pumps
6.2 for submersible motor-driven pumps
ON THE MOTOR-DRIVEN PUMP. IN THESE CASES, THE MANUFACTURER
IS RELIEVED FROM ALL RESPONSIBILITY REGARDING INJURY TO
PEOPLE AND SUBSEQUENT DAMAGE TO ADJACENT ITEMS AND/OR
THE MOTOR-DRIVEN PUMP ITSELF.
Once you have received the motor-driven pump, make sure that the packaging
is not broken or seriously damaged. If it is, immediately inform the person who
delivered it. After extracting the motor pump from its packaging, make sure that it
was not damaged during transportation. If it has been, inform the retailer within 8
days from delivery. Check the motor-driven pump plate to ensure that the indicated
characteristics are those requested by you.
The following parts, being normally subject to wear, have a limited guarantee:
• bearings
• mechanical seals
• grommets
• capacitors
If a fault that is not listed in the "TROUBLESHOOTING" table (chapter 10.1.)
occurs, please contact the nearest authorised retailer.
5. GENERAL SAFETY WARNINGS
Before starting the motor-driven pump, the user must follow the operations indicated
in this manual (PART 1 and PART 2), and apply them each time the motor-driven
pump is used or when maintenance is carried out on it.
5.1. PREVENTIVE MEASURES TO BE TAKEN BY THE USER
Users must observe the accident prevention regula-
tions that are in force in their countries at the time.
They must also pay attention to the motor-driven pump
characteristics (see "TECHNICAL DATA" in PART 2).
Always wear protective gloves when handling the
page 7
pump or performing maintenance.
page 7
page 7
While repairing or carrying out maintenance on the
motor-driven pump, disconnect the electric supply.
page 7
Doing this avoids accidental starting, which could
page 7
injure people and/or cause damage.
page 8
page 8
The device can be used by children aged above 8
page 8
years and by persons with reduced physical, sensory
or mental abilities, or who lack adequate experience
page 9
and knowledge of the product, provided that they are
page 9
supervised or have been adequately instructed on
page 10
its safe use and the relevant risks involved. Children
page 10
must not play with the device. Cleaning and mainte-
page 123
nance to be carried out by the user must not be effect-
ed by unsupervised children.
Any maintenance, installation or handling carried out
on the motor-driven pump while it is still being pow-
ered can seriously injure, or even kill, people.
When starting the motor-driven pump, users must en-
sure that their feet are not bare or, worse, immersed
in water. They must also ensure that their hands are
not wet.
Users must not operate or carry out any work on the
motor-driven pump that is not permitted in this manual.
Stop operation in case pump is in failure. Operation of
broken pumps can cause injury or damage property.
Do not touch the pump when the liquid handled is hot
water. Burns may result from high temperatures.
Do not touch the motor. The motor's surfaces will be
hot, and you could get burned if you touch them.
Do not touch the rotating parts such as the spindle,
shaft couplings, V-pulleys, etc. while the pump is run-
ning. Since these parts rotate at high speed, doing so
could result in injury.
Do not touch the live parts when the power is on. There
is a risk of electric shock.
Hide quick links:
Advertisement
Chapters
Table of Contents
