Table of Contents
Advertisement
Thermo Fisher Scientific
addr ip
This command reports the IP address of the analyzer.
Send:
addr ip
Receive:
addr ip 192.168.1.200
set addr ip address
This command sets the analyzer's IP address, where address consists of four
numbers ranging from 0-255 inclusive, separated by ".".
Note This command cannot be used when DHCP is on. Refer to the
DHCP command that follows for additional information.
Send:
set addr ip 192.168.1.200
Receive:
set addr ip 192.168.1.200 ok
addr nm
This command reports the IP netmask.
Send:
addr nm
Receive:
addr nm 255.255.255.0
set addr nm address
This command sets the netmask address, where address consists of four
numbers ranging from 0-255 inclusive, separated by ".".
Note This command cannot be used when DHCP is on. Refer to the
DHCP command that follows for additional information.
Send:
set addr nm 255.255.255.0
Receive:
set addr nm 255.255.255.0 ok
addr ntp
This command reports the IP address for the network time protocol server.
See "Network Time Protocol Server" in the Communications Settings"
section of the "Operation" chapter for more information.
Send:
addr ntp
Receive:
addr ntp 10.209.43.237
set addr ntp address
This command sets the network time protocol server address, where address
consists of four numbers ranging from 0-255 inclusive, separated by ".".
Send:
set addr ntp 10.209.43.237
Receive:
set addr ntp 10.209.43.237 ok
Communications Configuration
Partisol 2025i and Partisol 2025i-D Instruction Manual
C-Link Protocol Commands
▲
▲
B-23
Advertisement
Table of Contents
Troubleshooting
