Table of Contents
Advertisement
MAINTENANCE
L540E CERAMIC BURNER REMOVAL / INSTALLATION
REMOVAL
1) Remove left and right side panels by sliding them forward - see below.
2) Lift the Burner slightly while pulling forward to clear the mixing tube.
3) To install - reverse Steps 2 and 1.
44
All manuals and user guides at all-guides.com
Important Note:
INSTALLATION
Care must be taken when installing the burner into the fi rebox.
Do not damage, knock or scrape the pilot assembly.
The fl ame sensor and ignition lead are fragile and can be damaged
*Satin black paint is included if touch ups are required.
A correctly installed burner - the burner is back far enough,
lower the front edge so that the front fl ange of the burner
(underneath) sits down into the grooves in the burner mount-
ing brackets Left and Right. There will be a small gap between
the Ceramic Burner and the fi rebox Bottom Flange. The Burner
should be situated about ¼" (6mm) inside the front edge of the
fi rebox.
6mm
L540E-2 / HZI540E-2 Direct Vent Gas Insert
easily.
Advertisement
Table of Contents
