Table of Contents
Advertisement
Area of application
The product meets the following requirements:
Area of application
Equipment in areas without special
protection
Industry
Domestic
1
CTR / TBR 15
CTR / TBR 17
2
CTR / TBR 3
Installation guidelines
The products meet the requirements if you adhere to the installation and safety instructions
contained in the product documentation during installation and operation.
2.12.1.2
FM, UL and CSA approvals for all SINAUT ST7 products
FM approval
The SINAUT ST7 products included in the "List of SINAUT ST7 products" are certified as
follows:
FM Approval according to Factory Mutual Approval Standard Class Number 3611, Class I,
Division 2, Group A, B, C, D
Injury to persons and damage to property is possible.
Injury to persons and damage to property can occur in hazardous areas in the connecting
cables are removed while a SINAUT ST7 device is in operation.
Always turn off the power to SINAUT ST7 devices before removing connecting cables in
hazardous areas.
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
In accordance with the EU directives mentioned above, the EU conformity
declarations are available for the relevant authorities at the following
address:
Siemens Aktiengesellschaft
Industrial Solutions & Services
I&S IS 6 E D
Postfach 3249
D-91050 Erlangen
-
* EN 55022 (A) : 1998
** EN 55022 (B) : 1998
Analog leased lines, 2-wire
Analog leased lines, 4-wire
Digital leased lines
WARNING
Introduction to the SINAUT ST7 system
2.12 Standards and approvals of SINAUT ST7 products
Requirements
Emission
Immunity
EN 60870-2-1 : 1996
107
Advertisement
Table of Contents
