Table of Contents
Advertisement
Introduction to the SINAUT ST7 system
2.12 Standards and approvals of SINAUT ST7 products
Explosion Protection Directives
Complying with EN 50021 (electrical apparatus for potentially explosive atmospheres; Type
of protection "n")
Note
When using (installing) SIMATIC NET product in zone 2 hazardous areas make sure that
you note the following special conditions!
You will find these conditions here:
• on the SIMATIC NET Manual Collection CD
• on the Internet at the address
Machinery directive
The product remains a component according to Article 4(2) of the EC Machinery Directive
89/392/EC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine. Before the final product can be put into
operation, it must be tested to ensure that it conforms with the directive 89/392/EC.
Installation guidelines
The product meets the requirements if you adhere to the installation guidelines included in
this manual during installation and operation.
Personal injury and property damage can occur.
By installing expansions that are not approved for SINAUT products or their target systems,
the requirements and regulations relating to safety and electromagnetic compatibility may
be violated.
Use only expansions approved for the system.
Notes for Australia
The above listed SINAUT products meet the requirements of the standard AS/NZS 2064
(Class A).
112
II 3 G EEx nA II T3..T6
http://www4.ad.siemens.de/WW/news/en/13702947
WARNING
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
Advertisement
Table of Contents
