The Tim 3V-Ie Variants - Siemens SIMATIC NET SINAUT ST7 System Manual

Introduction to the SINAUT ST7 system
2.3 SINAUT TIM communication modules
2.3.2

The TIM 3V-IE variants

The TIM 3V-IE is available in standard and advanced versions. The two communications
processors share the following properties:
● TIM without integrated modem, single width
● For installation as a communications processor (CP) in an S7-300
● With a TIM 3V-IE, an S7-300 CPU or a C7 control system can then handle SINAUT
● It has two interfaces:
● The SINAUT TD7 software is integrated on the TIM (TD7onTIM)
● Modules can be replaced without the need for a programming device
The following properties are different on the TIMs:
SINAUT communication over
Use as
Data memory
Number of S7 connections
Can be combined with other
TIMs in the rack
Communication over MPI of the
S7-300 CPU
The following figure shows a TIM 3V-IE.
22
communication:
– Over any SINAUT WAN with SINAUT ST7 and SINAUT ST1 partners
– Over an Ethernet-based network (WAN or LAN) with SINAUT ST7 subscribers
– RS-232 interface for connection of required WAN transmission equipment
– RJ-45 interface for attachment to Ethernet
TIM 3V-IE
or
RS-232 RJ-45
Station
•
16,000 data messages
8
no
no
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
TIM 3V-IE Advanced
and
RS-232 RJ-45, also as
redundant transmission path
Station
•
Nodes
•
Master station
•
32,000 data messages
20
yes
yes