Siemens SIMATIC NET SINAUT ST7 System Manual page 90

Introduction to the SINAUT ST7 system
2.9 The SINAUT ST7 standard software package
Figure 2-25 The SINAUT ST7 configuration tool
The
subscribers. Where necessary, you can make subscriber-specific adaptations, for example,
changing the SINAUT subscriber number of the individual devices or the configuration of
message texts to be sent as an SMS. Subscriber management also involves the
configuration of the data messages to be sent and received if the message generation and
evaluation is to be performed by the TIM (only possible for TIMs with TD7onTIM
functionality). Based on the configuration data, the tool generates the system data blocks
(SDBs) for the CPUs and TIMs. If the SINAUT TD7 software for the CPU is used, the tool
also prepares records and communication data blocks for the CPUs and enters them in the
block directories of the CPUs along with the blocks (FBs, FCs) required by the individual
CPUs for SINAUT communication.
The third tool
which include SINAUT ST1 devices. This is a convenient utility with which addresses can be
synchronized for SINAUT ST1 when necessary.
The following figure illustrates how SMS messages can be configured conveniently in
subscriber administration. The configuration results in the automatic generation of data
blocks containing texts and the corresponding function blocks that are saved in the block
directory on the relevant CPUs.
90
Subscriber administration
SINAUT ST1 - configuration overview
tool then provides the user with a list of all available SINAUT
is required only for configuring systems
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06