Volvo EPA2007 D13F Reference Manual page 148

142 BASIC SERVICE
Note: VCS coolant is used to protect the cooling system.
Remove and Replace
1 Close the shut-off valve on the coolant pump housing.
Note: In the closed position, the pin on the shut-off valve should be horizontal.
2 Place a suitable container below the filter to collect spilled coolant.
3 Using filter wrench J 48061 or equivalent, unscrew the filter and discard it safely.
4 Apply a light film of coolant on the face of the new filter gasket.
5 Screw the new filter on the threaded nipple extending from the mounting flange.
6 Using the filter wrench, tighten the filter one full turn after the gasket contacts
the base.
7 Open the shut-off valve on the coolant pump housing.
8 Check for any coolant leaks.