Table of Contents
Advertisement
Using the Battery Charger
After unpacking the unit for
the first time, please charge
the batteries for at least
10 hours before operation.
To charge the system battery, plug the charger/power supply cable into the Delta X6
and plug the other end into an AC outlet. The LED on the battery charger will light
up. The color of the LED indicates the charging status as follows:
• RED means fast-charge mode. The battery is very low or completely
discharged.
• ORANGE means trickle-charge mode. The battery is not yet fully charged.
• GREEN means no charging. The battery is fully charged.
Determining Battery Status
There are two LEDs on top of the Delta X6 that indicate battery status. The GREEN LED
will light whenever the power is switched on, unless the battery is dead. As the battery
CHANNEL
CHANNEL
System Top View
Connect
AC Cord
to Charger
Connect
to 110V AC
discharges, the RED LED will begin to glow, and the
GREEN LED will stay lit. When the RED LED is
glowing brightly, the battery is very low. Once the
battery discharges to an unusable level, the system
7100R
will shut off and you will need to connect the
UHF
DIVERSITY
LightSPEED
RECEIVER
A
B
battery charger.
LOW
RF
SCAN
SQ
BAT
WM 2
BASS
While the system is charging it may be left on and
TREBLE
operated as normal. It is designed in such a way
AUX IN/
that it can provide power for the system while the
MIC IN
WM 2
WM 1 Knob
WM 1
POWER
Battery Status LEDs
ON
RED:
GREEN:
LOW
FULL
WM 1
BATT
BATT
• Red = Low Battery
7100R
UHF
DIVERSITY
• Green = Power ON
LightSPEED
RECEIVER
A
B
LOW
RF
SCAN
SQ
BAT
Power for the System
• After the system is fully charged, turn the
WM1 Knob clockwise to turn the system on.
• The green LED will light.
Controls and Functions
Power/Charging
LED
C H A R
A X 6
D E L T
batteries are charging. However,
to fully charge the system, it
should be switched OFF until the
LED shows GREEN on the battery
charger.
Back Panel
G E R
Connect
to Delta X6
2
Advertisement
Table of Contents
