Table of Contents
Advertisement
Operating Instructions
Wireless Transmitter
Handheld Microphone
Channel Selection – Handheld Transmitter
Once a channel has been selected on the receiver, you now need to select that same
channel on the handheld transmitter. If you have a belt-pack transmitter, go to
for channel selection instructions.
Setup Screens
selectable with
the UP and DOWN
Arrow Buttons
CH: 002
CH: 002
720.500M
Red
LED
ON/OFF
Switch
• Turn the microphone on by sliding
the switch on the barrel to the ON position. The red LED will flash once.
• Use the "up" and "down" buttons to select a screen that shows the current channel.
• To change the channel, press and hold the "SET" button on the bottom of the
microphone until there is a blinking cursor on the LCD display window
(approximately 3 seconds).
• Use the "UP" and "DOWN" buttons to set the channel to match the receiver.
• Press and hold the "SET" button again until the blinking cursor disappears and the red
LED flashes (approximately 3 seconds).
T T T T T ransmission Frequency in MHz:
ransmission Frequency in MHz:
ransmission Frequency in MHz:
ransmission Frequency in MHz:
ransmission Frequency in MHz: Press the "UP"
button once to view the transmission frequency in
MHz of the currently selected channel.
11
NiMH
AKLN
SENS SET
LEVEL [2]
LS
HM-900
LCD
Display
NOTE: Transmitters and receivers
are available in 5 different frequency
groups. Verify that the letter code that blinks
on the receiver (when powered ON) matches
the letter code on the frequency sticker in
the battery compartment of the transmitter.
LOCK
LOCK
DOWN
HM-900
CH: 002
720.500M
page 16
SET
SET
UP
Advertisement
Table of Contents
