Table of Contents
Advertisement
Wireless Transmitter
L ig h
t S P E
Belt-pack
E D
Channel Selection – Belt-pack Transmitter
Once a channel has been selected on the receiver, you now need to select that same
channel on the belt pack transmitter.
NOTE: Transmitters and receivers are available in 5 different frequency groups. Verify that the letter
code that blinks on the receiver (when powered ON) matches the letter code on the frequency sticker in
the battery compartment of the transmitter.
ON/OFF
Switch
LCD
Display
• Turn the transmitter ON by pressing and holding the Power button on the side
(approximately 2 seconds). The LCD display will appear.
• Open the plastic door by depressing the latches on each side.
• Use the "up" and "down" buttons to select a screen that shows the current channel.
• To change the channel press and hold the "SET" button until there is a blinking
cursor on the LCD display window (approximately 3 seconds).
• Use the "Up" and "Down" buttons to set the channel to match the receiver.
• Press and hold the "SET" button again until the blinking cursor disappears
(approximately 3 seconds).
T T T T T ransmission Frequency in MHz:
ransmission Frequency in MHz: Press the "UP"
ransmission Frequency in MHz:
ransmission Frequency in MHz:
ransmission Frequency in MHz:
button once to view the transmission frequency in
MHz of the currently selected channel.
Red LED
Mute
Button
L i g h
t S P E
E D
Operating Instructions
Setup Screens selectable with
the UP and DOWN Arrow Buttons
CH: 001
CH: 001
720. 250M
Toggle
Set
UP
CH: 001
720.250M
NiMH
AKLN
LS
BP-900
Door
Latch
Toggle
DOWN
16
Advertisement
Table of Contents
