Wireless Receivers - Lightspeed Delta X6 Manual

Hide thumbs Also See for Delta X6:

User manual (34 pages)

User manual (40 pages)

Table of Contents

Turn the DELTA X6 On

1. Rotate the WM1 knob

clockwise to turn on.

2. The green LED will light, and the red LED above will glow if the battery is low.

3. When the system is switched on, the receiver will have two letters flashing on the

screen to indicate the corresponding frequency group (see chart on page 22).

Channel Selection - Receiver

Each receiver has 100 user-selectable channels to choose from. You can either select a

channel manually or by pressing the "SCAN" button, which will automatically select a

clear channel.

4. CLEAR CHANNEL SCAN (Recommended): Make sure the transmitter(s) is

OFF before pressing this button. When this button is pressed, the receiver will

cycle through all 100 channels and select a clear frequency (this process takes

about 20 seconds). Once the receiver selects the clear channel, you will need to

select the same channel on the corresponding transmitter (handheld or belt-pack).

IF YOU HAVE A SECOND RECEIVER (WM2): Verify that WM1 is operating on

a clear channel, and the transmitter for WM1 is turned ON. Make sure the

transmitter for WM2 is turned OFF, and then press the "SCAN" button on the

WM2 receiver. After the WM2 receiver selects a clear channel, set the WM2

transmitter (handheld or belt-pack) to the selected channel.

Manual Channel Selection

5. Pressing the Left Channel button changes the first number (0-9).

6. Pressing the Right Channel button changes the second number (0-9). Once a

frequency is selected, you will need to select the same channel on the

corresponding transmitter (handheld or belt-pack).

NOTE: There are 5 different groupings of 100 channels available, which are sent out to

maximize clear channels in a specific geography. When the system is powered on, the two

letters that initially blink in the Channel window on the receiver indicate the frequency group

(see chart on page 22 for further details).

WM 1

Knob

Battery

Low LED

RED:

(red)

LOW

BATT

Battery

OK LED

(green)

Operating Instructions