Table of Contents
Advertisement
Operating Instructions
Wireless Microphone Operation
1. RF Indicator Lights: When both the system and the transmitter are on and
operating on the same channel you will see an RF Indicator Light (either A or B) on
the receiver.
2. Volume Adjustment: While speaking into the microphone,
slowly turn the WM1 Volume knob (or WM2 depending on which
microphone you are operating) clockwise until you reach the desired level.
NOTE: Do not stand directly in front of the DELTA X speaker with the
microphone on. This will result in feedback or 'squealing'. It is best to
stand behind or off to the side of the unit when setting volume level.
3. Squelch Adjustment: In areas that may have very high radio frequency traffic, it
may be necessary to adjust the squelch level to block out potential interference.
• Maximum squelch (full clockwise) reduces system reception range, but also
reduces the potential for system interference.
• Minimum squelch (full counterclockwise) increases reception range, but also
increases the potential for system interference.
NOTE: In most cases it will not be necessary to adjust the squelch
level. Since the system already has the clear channel scanner, this
will take care of most interference problems.
4. Transmitter Low Battery Indicator: This LED will light to indicate the batteries
in the corresponding transmitter are low and need to be replaced or recharged.
19
WM 1
2
Knob
RED:
LOW
BATT
100-channel UHF Receiver Module
WM 1
POWER
ON
CHANNEL
GREEN:
FULL
BATT
Battery
7100R
UHF TRUE
DIVERSITY
LightSPEED
RECEIVER
A
B
LOW
RF
SCAN
BAT
Low
1
4
RF LED
Squelch
Indicators
SQ
3
Advertisement
Table of Contents
