Table of Contents
Advertisement
Wireless Transmitter
L ig h
t S P E
Belt-pack
E D
5. To Change the Battery Type Setting
• Press the "UP" button twice to get to the battery type screen.
• Press and hold the "SET" button until a blinking cursor appears.
• Use the UP and DOWN buttons to make a selection.
• Press and hold the "SET" button again until the blinking cursor disappears.
Battery
Compartment
NiMH
AKLN
5
Charging the Batteries (NiMH Rechargeable Batteries ONLY)
Make sure there are NiMH Rechargeable Batteries in the transmitter before plugging in
the charger.
Charger Status LED
• RED = charging in progress
• GREEN = batteries fully
charged
L i g h
t S P E
E D
UP
Button
6
DOWN
Button
WARNING: Do not attempt to charge alkaline batteries. They can
overheat and expand, creating a significant hazard and damaging
the transmitter. (This is not covered by warranty.)
Transmitter
Charger
Charger
Connector
Operating Instructions
6. Replacing the Batteries
• Open the plastic door by
Set
depressing the latches on each
Button
side.
• Insert two AA batteries and snap
the door closed. Note the polarity
in the battery compartment.
Door
Latch
Typical battery life is about 8
hours.
• Switch the transmitter power off.
• Insert the small DC plug into the
jack on the side of the transmitter
labeled "CHG".
• Plug the other end of the charger
into any standard 110 VAC outlet.
• The Red LED on the charger will
light indicating charge is in process.
• When the batteries are fully
charged, the light on the charger
will turn green. A full charge can
take up to 8 hours.
18
Advertisement
Table of Contents
