Table of Contents
Advertisement
Replacing the Batteries
1. To replace the batteries, unscrew the end cap to reveal the battery compartment.
2. Remove or replace the batteries as shown. The microphone requires two AA
sized batteries stacked end to end.
3. Note the polarity in the battery compartment. Typical battery life is about 8 hours.
IMPORTANT! Replace batteries with the same type, (alkaline or NiMH),
End Cap
Charging the Batteries (NiMH Rechargeable Batteries ONLY)
Make sure there are NiMH Rechargeable Batteries in the transmitter before plugging in
the charger.
• Switch the transmitter
power off.
• Insert the small DC plug
into the jack on the bottom
of the transmitter.
• Plug the other end of the charger
into any standard 110 VAC outlet.
• The Red LED on the charger will light
indicating that charging is in progress.
• When the batteries are fully charged, the light on the charger will turn green.
A full charge can take up to 8 hours.
that were installed in your handheld microphone.
1
WARNING: Do not attempt to charge alkaline batteries. They
can overheat and expand, creating a significant hazard and
damaging the transmitter. (This is not covered by warranty.)
Transmitter
Charger
Operating Instructions
Wireless Transmitter
Charger Status LED
• RED = charging in progress
• GREEN = batteries fully charged
Charger
Connector
Handheld Microphone
2
3
Handheld Microphone
End View
LOCK
SET
HM-900
14
Advertisement
Table of Contents
