Table of Contents
Advertisement
Controls and Functions
Wireless Receivers
Control Panel
1. 1. 1. 1. 1. Channel Control (00-99):
Channel Control (00-99):
Channel Control (00-99):
Channel Control (00-99):
Channel Control (00-99):
The left button controls the
number on the left (0-9). Each
touch of the button moves the
number up one until it gets to
nine, and then it cycles back to
zero. The right button has the
same function for the number
on the right.
2. 2. 2. 2. 2. T T T T T ransmitter Low Batter
ransmitter Low Batter
ransmitter Low Batter
ransmitter Low Battery Indicator:
ransmitter Low Batter
the transmitter (belt-pack or handheld) set to the same channel.
3. 3. 3. 3. 3. RF Channel "A" Indicator:
RF Channel "A" Indicator:
RF Channel "A" Indicator: The "A" LED lights up indicating the "A" channel tuner
RF Channel "A" Indicator:
RF Channel "A" Indicator:
is receiving the strongest RF signal.
4. 4. 4. 4. 4. RF Channel "B" Indicator:
RF Channel "B" Indicator: The "B" LED lights up indicating the "B" channel tuner
RF Channel "B" Indicator:
RF Channel "B" Indicator:
RF Channel "B" Indicator:
is receiving the strongest RF signal.
5. 5. 5. 5. 5. Scan:
Scan:
Scan:
Scan:
Scan: Press this button to automatically select a channel that is free from
interference.
6. 6. 6. 6. 6. Squelch Adjustment:
Squelch Adjustment:
Squelch Adjustment: Adjusts the squelch level for elimination of RF interference.
Squelch Adjustment:
Squelch Adjustment:
7. 7. 7. 7. 7. Receiver Power/Volume Adjustment:
Receiver Power/Volume Adjustment:
Receiver Power/Volume Adjustment: The receiver volume adjustment is covered
Receiver Power/Volume Adjustment:
Receiver Power/Volume Adjustment:
with a plastic cap. The volume is adjusted at the factory to provide the best signal
level and minimum noise. There is no need to adjust the receiver volume in the
field.
Installing or Replacing a Receiver Module:
Installing or Replacing a Receiver Module:
Installing or Replacing a Receiver Module:
Installing or Replacing a Receiver Module:
Installing or Replacing a Receiver Module:
Note: Make sure the Delta X6 is turned off.
Remove the two screws securing the module
or filler panel using a small phillips screwdriver.
To remove the module, use a small flat-blade
screwdriver. Carefully insert the blade under the
face plate edge and nudge it outward. Grasp the
edges with both hands and slide outward. Install
the new module by aligning it with the guide rails
and sliding all the way in to engage the connector
at the rear of the module. Replace the two screws.
5
y Indicator:
y Indicator:
y Indicator:
y Indicator: This LED will light to indicate a low battery in
100-channel UHF Receiver Module
7100R
UHF TRUE
DIVERSITY
LightSPEED
RECEIVER
A
CHANNEL
LOW
BAT
1
3
2
Remove
Screw
CHANNEL
7
B
RF
SCAN
SQ
5
6
4
Remove
Screw
7100R
UHF TRUE
DIVERSITY
LightSPEED
RECEIVER
A
B
LOW
RF
SCAN
SQ
BAT
Advertisement
Table of Contents
