Lightspeed MULTIMIKE Registration Manual

MULTIMIKE REGISTRATION GUIDE
STANDARD REGISTRATION
FLEXMIKE REGISTRATION (OTHER REGISTERED COMPONENTS IN PLACE)
(Particularly valuable when Multimike is not easily accessible)
Note: Multimike systems do not use MIC 2 status lights.
For users adding a second Flexmike or replacing a lost or malfunctioning Flexmike.
1. Start with the Multimike plugged in and powered on.
2. If replacing a Flexmike, make sure the malfunctioning Flexmike is powered off.
3. If a other Flexmikes, Sharemikes or a Media Connector is present, power them
on and wait until each has a solid blue light ("Ready").
4. Power on the new Flexmike. The microphone 1 light should start blinking.
5. Open the new Flexmike battery compartment and pull the battery out (leaving
it plugged in) to reveal the registration button.
6. Use another registered functional component (existing Flexmike, Sharemike or
Media Connector) to trigger the registration function in Multimike.
• Using a paperclip with the end straightened out, press and hold the registration
button for 3 seconds inside the functioning Flexmike. This triggers registration in
the Multimike and the Multimike's #1 amber light will begin blinking.
7. Briefly press the registration button on the new or replacement Flexmike. The #1
blue light will start blinking alternately.
8. After several seconds, the #1 light on the Multimike will turn solid and the #1 light on the Flexmike will remain blinking, then turn solid.
9. The registration is complete. You can begin speaking into the new
Flexmike to verify there is audio.
10. Place system ID number (attached to the Multimike Quickstart
Guide) on the new Flexmike.
NOTE: if at any point, the Multimike or Flexmike lights begin
blinking rapidly, that indicates a registration error. Turn the new
Flexmike off and repeat steps 4-9.
Solid light
Power On
(Existing Good Flexmike)
Blinking lights
MICROPHONE AUDIO IN TONE
POWER
1 2
MIN MAX MIN MAX TREBLE BASS
Solid lights
MICROPHONE AUDIO IN TONE
POWER
1 2
MIN MAX MIN MAX TREBLE BASS
USB POWER
5V/0.2A
REGISTER
USB POWER
+ MIC LINE
5V/1.5A
AUDIO IN BAL. AUDIO OUT AUDIO OUT AUDIO OUT/DC IN
Blinking lights
Power On
(NEW Flexmike)
Registration
Button
Registration ID Labels
Apply to system components to indicate which parts are registered
as a system. Keep registered items together when storing away.
334-0162-02-00-01
00-01 00-01
00-01
00-01
00-01 00-01
00-01
00-01
00-01 00-01
00-01
00-01 00-01
00-01
00-01
00-01 00-01
00-01
00-01
00-01 00-01
00-01
RETAIN EXTRA LABELS IN THE EVENT A COMPONENT IS REPLACED OR ADDED.
10101
00-01
00-01
00-01
00-01
00-01
00-01