Cable Adjustments - Body Solid EXM2500 Assembly Instructions And Owner's Manual

Cables can stretch slightly when your gym is first used . If there is slack in the cables before resistance is
felt, the cables should be tightened . Cable tension can be adjusted in several ways:
Move the pulley up or down in Weight Stack Top M
Move the pulley up or down in Double Pulley Holder U2
Adjust the chain attached to the Main Base Frame A
Adjust the chain attached to the Small Pulley Holder W
To adjust your cables see the illustrations below . Do not over tighten the cables . If the cables are over
tightened you will notice the Top Plate d29 will be lifted off the weight stack .
b2
d6
First, remove the Weight Stack Pin a13 from the Weight Stack . This will release tension on the cables .
You can now remove the pulley inside Weight Stack Top M and move the pulley up or down to adjust the
cable tension .
D
2" x 4" Upright
First, remove the Weight Stack Pin a13 from the Weight Stack . This will release tension on the cables .
You can now remove the lower pulley inside Double Pulley Holder U2 and move the pulley up or down to
adjust the cable tension .

Cable Adjustments

M
Weight Stack Top
a8
Double Pulley Holder
54
b2
d6
a8
U2