Features And Components - Allied Telesis AT-8316F/MT Installation Manual

Features and Components

The switches have the following common hardware features:
# Half- or full-duplex operation on all switched ports delivering
up to 200 Mbps of bandwidth to servers, routers, workstations,
or other switches
# Auto-negotiation on all 10Base-T/100Base-TX ports for speed
and duplex in compliance with IEEE 802.3u specifications
(AT-8324 switch only)
# Non-blocking, clear-channel architecture delivers wire-speed
switching and up to 14 Gbps aggregate bandwidth
# Store-and-forward switching mode
# 8K MAC addresses per switch with automatic aging
# 4 MB SDRAM per eight 10Base-T/100Base-TX or 100Base-FX
ports
# 2 MB Flash memory for software upgrades
# In-band Telnet capability for remote switch management
# AT-S25 software and Omega management software
# Two stacking ports for interconnecting switches to create
logical switches
# One expansion slot for the optional AT-Stack8 Stacking Matrix
Module for creating logical switches of up to eight switches
# Two expansion slots for optional uplink expansion modules
# RS232 connector for local switch management
# IEEE 802.1Q compliant Virtual LAN (VLAN) tagging support
# IEEE 802.1P compliant Quality of Service
# Two priority queues/levels per-port based on tagging
information (IEEE 802.1P)
# IEEE 802.1d Spanning Tree Protocol
# SNMP Management Information Base (MIB) II, SNMP MIB
extensions, Bridge MIB (RFC 1493), Ethernet MIB (RFC 1643),
and Interface MIB (RFC 1573)
# BootP and DHCP support
# Port trunking for increased bandwidth to end nodes
AT-8316F and AT-8324 Installation Guide
13