Table of Contents
Advertisement
Installing the Switch
58
3. If you purchased a redundant power supply (RPS) unit for the
Ethernet switches, connect the RPS unit to the R.P.S. Input
connectors on the rear of the switch by following the directions
included with the RPS system.
Caution
If you intend to use a redundant power supply (RPS) with the
switch, check to be sure that the cable with the RPS unit is
compatible with the RPS Input Port on the switch. The pin
assignments for the port are provided in Appendix B.
4. Go to the next procedure, Setting Up a Terminal for Local
Management on page 3-59, to access the Omega management
software on the switch.
Advertisement
Table of Contents
