Table of Contents
Advertisement
Installing the Switch
44
As power is applied to the switch, the Fault LED (shown in
Figure 3-2) flashes as the switch runs a series of internal self
tests. After the switch has finished running its self tests, the
Fault LED will stop flashing and will remain OFF.
RS-232
TERMINAL PORT
For information on all the switch LEDs, refer to the section
Switch LEDs on page 1-16.
6. If you purchased a redundant power supply (RPS) unit for the
Ethernet switch, connect the RPS unit to the R.P.S. Input
connector on the rear of the switch by following the directions
included with the RPS system.
Caution
If you intend to use a redundant power supply (RPS) with the
switch, check to be sure that the cable with the RPS unit is
compatible with the RPS Input Port on the switch. The pin
assignments for the port are provided in Appendix B.
7. Connect the data cables to the ports on the switch.
8. Go to the procedure Setting Up a Terminal for Local
Management on page 3-59 to access the Omega management
software on the switch.
STATUS
Fault LED
FAULT
MASTER
RPS
PWR
RESET
Figure 3-2 Fault LED
Advertisement
Table of Contents
