Xilinx Alveo X3522 User Manual page 50

Note: If devlink is not available, this information is instead available via sysfs:
# cat /sys/class/net/enp1s0f0np0/device/versions
3. Confirm that versions are as expected.
Confirm Current Configuration
You can view the current configuration in the fw.psid field of the output from the devlink
dev info command:
1. Confirm that you can see the Xilinx PCIe devices for the X3522, including one or more
Ethernet controllers.
# lspci -D -d 10ee:
0000:01:00.0 Ethernet controller: Xilinx Corporation Device 5084
0000:01:00.1 Ethernet controller: Xilinx Corporation Device 5084
2. Use devlink to get the configuration for the first Ethernet controller that is reported. It is
output in the fw.psid field:
# devlink dev info pci/0000:01:00.0
pci/0000:01:00.0:
driver xilinx_efct
serial_number <serial_number>
versions:
fixed:
board.id X3522
running:
...
stored:
...
fw.psid <configuration>
3. Confirm that the reported <configuration> is as expected.
The following table shows some substrings that you might see within the configuration value.
Table 7: fw.psid Configuration Substrings
fw.psid Configuration Substring
enable_hybrid
disable_hybrid
enable_uefi
disable_uefi
Confirm UEFI Enablement
To determine whether UEFI is enabled, you can use devlink to get the current configuration.
See Confirm Current
UG1523 (v1.0) October 18, 2022
Alveo X3522 User Guide
Configuration.
Chapter 6: Programming the X3522
Meaningudioo up
Hybrid mode is enabled (the NIC is programmable)
Hybrid mode is disabled (the NIC is not programmable)
UEFI is enabled
UEFI is disabled
Send Feedback
www.xilinx.com
50