Confirm Success Of The Update - Xilinx Alveo X3522 User Manual

4. Confirm the version numbers are as expected:
# ethtool -i enp1s0f0np0
driver: xilinx_efct
version: 1.2.1.0
firmware-version: 1.15.3.13
expansion-rom-version: 1.3.6.10
bus-info: 0000:01:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: no
supports-register-dump: no
supports-priv-flags: no

Confirm Success of the Update

Now confirm that the X3522 is operating properly and that your update was successful.
Ensure that you are logged in as root before you perform any of these procedures.
Confirm Version Information
Confirm that the components of the X3522 have the expected versions:
1. Confirm that you can see the Xilinx PCIe devices for the X3522, including one or more
Ethernet controllers.
# lspci -D -d 10ee:
0000:01:00.0 Ethernet controller: Xilinx Corporation Device 5084
0000:01:00.1 Ethernet controller: Xilinx Corporation Device 5084
2. Use devlink to get version information for the first Ethernet controller that is reported. For
example:
# devlink dev info pci/0000:01:00.0
pci/0000:01:00.0:
driver xilinx_efct
serial_number 0123456789ab
versions:
fixed:
board.id X3522
running:
fpga.rev 1_I5
fw.mgmt 1.15.3.13 (0) x3_llnic
fw.mgmt.suc 3.0.23.1000 type 0 (2022-08-12)
board.rev 1.1.0.0
fw.bundle_id 1.26.126.3538
stored:
fw.bundle_id 1.26.126.3538
fw.mgmt 1.15.3.13
fw.mgmt.suc 3.0.23.1000
fw.exprom 1.3.6.10
fw.psid x3522-factory-config
UG1523 (v1.0) October 18, 2022
Alveo X3522 User Guide
Chapter 6: Programming the X3522
www.xilinx.com
Send Feedback
49