Table of Contents
Advertisement
9. Connections of Display Unit
9.6 Connecting with Hard Disk Unit: FCU7-DA315-11 / FCU7-DA415-11 / FCU7-DA445-11
9.6 Connecting with Hard Disk Unit: FCU7-DA315-11 / FCU7-DA415-11 / FCU7-DA445-11
Connect hard disk unit to the connector HDD.
F140 cable comes with the hard disk unit (FCU7-HD001-1).
Hard disk unit can be mounted on the back of the keyboard unit FCU7-KB04 .
Keyboard unit
(Rear view)
(Note 1) When mounting the hard disk unit, face the cable lead-out side straight up and mount within ±15°.
(Refer to the section "5.5.1 FCU7-HD001".)
(Note 2) Do not turn the power OFF during access to the hard disk. Failure to observe this could cause the
units to malfunction. In case of emergency, always perform backups by having your important data
duplicated, etc. as MITSUBISHI will not guarantee the broken or lost data. Be sure to inform this
matter to the end users.
<Related items>
Cable drawing: "Appendix 2 (F140 cable)"
Connector pin assignment: "Appendix 3 (HDD connector)"
CAUTION
Do not apply voltages to the connectors other than voltages indicated in this manual. Failure to observe this could
cause the devices to rupture or damage, etc.
Incorrect connections could cause the devices to damage. Connect the cable to the designated connector.
Do not connect or disconnect the connection cables between each unit while the power is ON.
Display unit
(Rear view)
HDD
Red
mark
Hard disk unit
149
F140 cable
Advertisement
Table of Contents
