Mitsubishi Electric CNC 700 Series Connection Manual page 287

Appendix 9. Precautions for Use of Peripheral Devices and Commercially Available Devices
Appendix 9. Precautions for Use of Peripheral Devices and Commercially
Available Devices
Peripheral device
CF card
PCMCIA card
PS2 keyboard
PS2 mouse
Commercially available CF cards may not be compatible with MITSUBISHI units or
suitable for FA environment for temperature- or noise-wise. In the case of using it,
careful performance check must be required by the machine tool builder.
When inserting/removing a commercially available CF card, preferably, turn the
MITSUBISHI device's power OFF to avoid any troubles. When inserting/removing a
card while the power is ON, make sure to have sufficient time (approx. ten seconds
or more) in between.
Do not pull out the card or turn OFF the power during access to the CF card. Failure
to observe this could cause the memory contents to be erased. In case of
emergency, always perform backups by having your important data duplicated, etc.
as MITSUBISHI will not guarantee the broken or lost data. Be sure to inform this
matter to the end users.
Recommended products are the SanDisk products listed below:
64MB SDCFB-64-J60
128MB SDCFB-128-J60 (JAN: 4523052000300)
256MB SDCFB-256-J60 (JAN: 4523052000317)
512MB SDCFB-512-J60 (JAN: 4523052000324)
1.0GB SDCFB-1024-J60 (JAN: 4523052000331)
PCCARD adapter SDAD-38-J60 (JAN: 4523052000645)
The performance of the above recommended products were checked under given
conditions. The same performance may not be attained at the end-user side because
of the difference in system environment. Also, no absolute performance guarantee
can be provided even for the same type name as its constituent parts may differ.
Some products may have been discontinued. Contact the respective manufacturer or
distributor for inquiries about orders.
Same as above
MITSUBISHI will not provide performance guarantee and maintenance for
commercially available keyboard. Commercially available devices may not be
compatible with MITSUBISHI units or suitable for FA environment for temperature- or
noise-wise. In the case of using it, careful performance check must be required by
the machine tool builder.
Cable must be connected/disconnected after turning the unit's power OFF.
MITSUBISHI will not provide performance guarantee and maintenance for
commercially available mouse. Commercially available devices may not be
compatible with MITSUBISHI units or suitable for FA environment for temperature- or
noise-wise. In the case of using it, careful performance check must be required by
the machine tool builder.
Cable must be connected/disconnected after turning the unit's power OFF.
Precautions
(JAN: 4523052000294)
268