Mounting Options - Alarm.Com Knowledge Base Flex IO ADC-FLEX-100 Installation Manual

Hide thumbs Also See for Knowledge Base Flex IO ADC-FLEX-100:

Table of Contents

Mounting options

Consider the following mounting requirements. Review

Step 3: Mount the Alarm.com Flex IO™ sensor

diagrams and more information.

• Using screws: Holes are located in the battery

compartment.

• Using zip ties: Use cutouts at the top and bottom of

the device to make sure the Alarm.com Flex IO™

sensor is mounted flush to the install surface.

Important: A mounting tamper is located on the back of

the Alarm.com Flex IO™ sensor. This tamper button

must be fully pressed (until you hear a clicking sound) to

avoid reporting a mounting tamper malfunction.

If not applicable for your installation, tampers can be

disabled by updating device settings on the Partner

Portal or MobileTech.

https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Cellular_Sensors/Alarm.com_Flex_IO%E2%84%A2_sen...

for

Updated: Mon, 10 Oct 2022 23:21:36 GMT

Table of Contents

Do you have a question about the Knowledge Base Flex IO ADC-FLEX-100 and is the answer not in the manual?