Table of Contents
Advertisement
Input Wiring
If Loop will also be used, it is important to consider how
the wiring will be configured before mounting the
Alarm.com Flex IO™ sensor. For more information, see:
•
Alarm.com Flex IO™ sensor - Pull-Apart Installation
Guide.
•
Alarm.com Flex IO™ sensor - Wired Contact (Loop
Input) Installation
Guide.
DC Power Requirements
In addition to battery power, the Alarm.com Flex IO™
sensor can be powered with a DC converter. DC power
is optional for reed switch or input installations.
• Anything from 6-15VDC is acceptable.
• A minimum of 1 Amperage is required.
• For best performance, 18-22 AWG wire should be
used.
Important: DC power is required for relay installations
due to increased power demands.
Note: It is recommended to still install batteries for
backup power to prevent damage in case of a sudden
power loss. If batteries are not installed, a Low
Battery trouble condition will still appear on the customer
account. The Alarm.com Flex IO™ sensor uses battery
power in the event DC power is lost.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Cellular_Sensors/Alarm.com_Flex_IO%E2%84%A2_sen...
Updated: Mon, 10 Oct 2022 23:21:36 GMT
6
Advertisement
Table of Contents
Need help?
Do you have a question about the Knowledge Base Flex IO ADC-FLEX-100 and is the answer not in the manual?
Questions and answers