Alarm.Com Knowledge Base Flex IO ADC-FLEX-100 Installation Manual page 8

Hide thumbs Also See for Knowledge Base Flex IO ADC-FLEX-100:

Table of Contents

Signal strength

3 bars

4 bars

5 bars

6 bars

Step 2: Add the Alarm.com Flex IO™ sensor to an Account

After Step 1 is completed, and the installation location (including power and wiring considerations) has been identified,

proceed with adding the device to an account.

1. Log into the Partner Portal or MobileTech app.

2. Find the customer account.

3. Verify at least one Alarm.com Flex IO™ sensor has been added to their Service Package. The Alarm.com Flex

IO™ sensor is listed under Cellular Sensors.

4. Click Equipment.

5. Click Cellular Sensors.

6. Click Add a Cellular Sensor.

7. Using a screwdriver, open the battery compartment to find the Serial Number (Device IMEI) of the device.

8. Enter the Device IMEI number and follow the on-screen instructions to set up the device.

Note: Want to add an Alarm.com Flex IO™ sensor to an account without a Security System? Use the Partner Portal or

MobileTech to Create New Customer. For the Account Type, select Standalone (Video and/or Cellular Sensor).

https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Cellular_Sensors/Alarm.com_Flex_IO%E2%84%A2_sen...

LED pattern

1 red LED blink, followed by 3 yellow

LED blinks

1 red LED blink, followed by 4 yellow

LED blinks

1 red LED blink, followed by 5 yellow

LED blinks

1 red LED blink, followed by 6 yellow

LED blinks

LED visual

Updated: Mon, 10 Oct 2022 23:21:36 GMT

Table of Contents

Need help?

Do you have a question about the Knowledge Base Flex IO ADC-FLEX-100 and is the answer not in the manual?