Using Screws - Alarm.Com Knowledge Base Flex IO ADC-FLEX-100 Installation Manual

Hide thumbs Also See for Knowledge Base Flex IO ADC-FLEX-100:

Table of Contents

The Alarm.com Flex IO™ sensor can be mounted using either screws or zip ties.

Using screws

• Screw mounting holes are located in the battery

compartment. To avoid damaging the batteries, it is

recommended to remove them before installing

screws.

• Use two #8 Phillips screws to puncture the gasket

and securely mount the Alarm.com Flex IO™

sensor.

• Take care not to over-torque the screws. Power

tools should be avoided. If pilot holes are

necessary, a drill bit size of 5/64'' is recommended.

Using zip ties

• Zip ties should have a maximum width of 0.34

inches. UV resistant zip ties are recommended.

• Use the zip tie grooves at the top and bottom of the

Alarm.com Flex IO™ sensor to ensure a secure

installation. The magnet also has a zip tie groove

across the center.

https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Cellular_Sensors/Alarm.com_Flex_IO%E2%84%A2_sen...

Updated: Mon, 10 Oct 2022 23:21:36 GMT

Table of Contents

Do you have a question about the Knowledge Base Flex IO ADC-FLEX-100 and is the answer not in the manual?