Software Update - Rational SelfCookingCenter SCC Training Manual

Table of Contents

Advertisement

Software update

Software update
Only use the Original Rational USB Stick for Software update of SCC_WE and CM_P units.
The combined Rational USB Stick for Software update of SCC_WE and CM_P can be ordered with service part
number: 87.01.275.
Software update with other USB sticks are not possible.
When new software becomes available, it can be updated on RATIONAL USB by using
RATIONAL Loader on the USB stick without prior login to the service web site.
Software can only be updated to a higher version.
SCC:
Switch the unit ON.
Software update starts automatically.
The duration of a complete software update of SCC_WE can last a few minutes
Only when the start display shows disconnect the USB stick.
SCC Chain account:
Software of units with chain accounts shall only be updated when approved by the store owner or Rational.
In most cases chain account are based on an older software version.
Changing PCB:
Therefore the existing software on the spare part PCB must first be reset to accept an older software version.
-
Connect "RESET" USB stick to USB interface
-
Switch unit ON
-
When SCC_WE display shows, remove USB stick
-
Connect key account " ALL in ONE" USB stick to USB interface
-
Switch unit OFF and ON again
-
When SCC_WE display shows, remove USB stick
-
Press key "Copy data from SD card to PCB" for 10 seconds
CM_P:
Switch the unit ON.
The actual software of the unit is shown on the Timer display.
The existing software on the USB stick is shown on the temperature display.
The Prog/Start key is blinking. Pressing the Prog/Start key will start the software update.
After the software update up to 02-00-15 the identical software will be shown in both displays,
After the software update from 03-00-01 temperature and time is shown.
Now switch unit off and remove the USB stick.
Please always make sure your customer has the latest software version on his appliance.
V08 en, SCC
Connect the USB software update stick 87.01.275 with the USB interface at the bot-
tom left hand corner of the control panel.
- 44 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents