Changing PCB SCC
All calibration and selftest data are located on both the PCB and the SD card Only the user
manual and the HACCP data are only on the PCB.
For this reason a software update must be done after changing the PCB.
Changing pcb (pcb defective)
Isolate unit from power supply
Removed SD card for usage in new
PCB.
Remove faulty PCB
Insert SD card into new PCB
Connect USB stick with latest
software to USB port.
Reconnect unit to power supply and
switch unit ON
Software update to latest version
Only disconnect Software update
stick when basic SCC display is
shown.
Copy data from SD card to PCB
(press key 10 seconds)
- 41 -
V08 en, SCC