Table of Contents
Advertisement
GUIDE TO INSTALLATION
The following can be used as a checklist to verify all of the steps necessary for
complete installation of the DP1200 decoder.
1) Read all information in the section "Safety Precautions" at the beginning of this
manual.
2) Correctly position and mount the decoder within the reach of the barcode reader
cable, according to the information in paragraphs 2.3, 2.5.
3) Provide correct system cabling according to the signals necessary for your
application (see the applicable sub-paragraphs under 2.4).
4) Install the Configuration Disk.
Upon successful completion of the installation, the readme.hlp file is opened,
giving details about how to get started configuring your decoder.
See also the Guide to Rapid Configuration link.
Specific parameter details are available in the Help On Line.
Fine tuning of the scanner position for barcode reading can be
accomplished using the Test Mode as described in WinHost.
NOTE
The installation is now complete.
iv
Advertisement
Table of Contents
