Replacing the DPI blade cover
Attention:
cover is installed and closed. Do not attempt to override this protection.
The following illustration shows how to install the DPI blade cover.
To install the DPI blade cover, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. If you removed the bezel assembly, replace it. See "Replacing the bezel
3. Make sure that all components are installed and seated correctly and that you
4. Lower the cover so that the slots at the rear slide down onto the pins at the rear
5. Pivot the cover to the closed position, as shown in the illustration, until it clicks
Removing and replacing transceiver modules
This section provides instructions for installing XFP and SFP transceiver modules in
the DPI blade.
Note: The illustrations in this document might differ slightly from your hardware.
Handling a transceiver module
Before you install an XFP or SFP transceiver module, read the following
information:
v The housing of a transceiver module has an integral guide key that is designed
v Use minimal pressure when you insert the module into the port. Forcing the
v You can insert or remove the module while the BladeCenter unit is turned on.
v You must first insert the module into the port before you can connect the cables.
You cannot insert the DPI blade into the BladeCenter unit until the
on page 25.
assembly" on page 37 for instructions.
have not left loose tools or parts inside the DPI blade.
of the DPI blade, as shown in the illustration.
into place.
to prevent you from inserting the module incorrectly.
module into the port can cause damage to the module or the module port.
Chapter 4. Removing and replacing DPI blade components
31