Product Overview - Emerson PACSystems RX3i User Manual
Genius communications gateway
Hide thumbs
Also See for PACSystems RX3i:
- User manual (232 pages) ,
- Application manual (37 pages) ,
- Manual (37 pages)
Table of Contents
Advertisement
User manual
GFK-2892G
1.5
Product Overview
Features of the GCG001 module include:
•
Attachment of two RJ-45 Ethernet connections (Ports 1 & 2)
•
Support for both star (switched) and linear (daisy-chained) network topologies
•
Supports Ethernet Media Redundancy Protocol (MRP)
•
LEDs to indicate Ethernet status (ACT & LINK)
•
Genius bus terminal block attachment
•
Supports Genius Redundancy consisting of a single Genius bus with two GCG001
Gateways, one at SBA #30 and the other at SBA #31.
•
LED to indicate Genius Communications Status (COM)
•
LEDs to indicate module status (refer to module header)
•
Panel-mount (typical)
•
Optional mounting in RX3i expansion slot
•
Cable tie-down loop on underside of module (at front)
•
24Vdc power connector on underside of module
•
0.2A maximum current draw
•
Secure Digital (SD) Card Slot, accessible at rear of module
•
Firmware load pushbutton, accessible at rear of module
Figure 2: GCG001 Module
Note:
Introduction
Although the hardware supports the 10/100BASE TX Ethernet standard, PROFINET I/O over
wired infrastructure must be 100Mbps full-duplex or faster. 10Mbps should not be used for
PROFINET.
Chapter 1
Sep 2019
5
Advertisement
Table of Contents
