User manual
GFK-2892G
6.4.18
COMMREQ #25: Write Data Command
This command is used to set data values in a Genius High-speed Counter.
Command Block for the Write Data Command
Address
Address +1
Address +2
Address +3
Address +4
Address +5
Address +6
Address +7
Address +8
Address +9
Address +10
Address +11
Address +12
COMMREQ/Data_Init_Comm Programming
Command Length
No Wait
Status Block memory type
Status Block offset
Idle timeout value
Max. communications time
Command number
PROFINET Device number
Genius Device Number
Command Code
Counter Number
Data to be written
bytes 1, 2
bytes 3, 4
7
0
70 (%I), 72 (%Q), 8 (%R), 10 (%AI), 12 (%AQ) or
196 (%W)
Beginning address for the COMMREQ Status
Block.
0
0
25
1-255: The device number of the targeted GCG
Genius Gateway.
1-29: the SBA of the targeted Genius Device to
which data is to be transmitted.
See Read/Write Data Command Code Table
below.
1-4
Four bytes of data to be written to the target
Genius HSC
(Byte 4 is MSB, Byte 1 is LSB)
Chapter 6
Sep 2019
89