Accessory Use - Maxi-Cosi Magellan LiftFit Manual

Accessory Use

For Use in
Forward-Facing Mode
Spring Assist Out-of-the-Way Harness Covers
Harness covers help provide comfort to your child's neck. If the
harness covers will not allow proper positioning of the chest clip or
interfere with getting a tight enough harness fit for a smaller baby,
remove them and DO NOT use.
Store until your child is large enough to use the harness covers
while maintaining a properly fitting harness.
To remove:
1. Undo the fasteners on the headrest pad.
2. Pull the fastening strips on the harness
covers apart.
Front View
3. Pull the harness straps out of the harness
covers.
4. Slide the harness covers out from behind
the headrest pad.
To install:
Back View
1. Undo the fasteners on the headrest pad.
2. With the front of the harness covers facing
you, slide them behind the headrest pad.
3. Pull the harness covers down towards you
and place the harness straps into the harness
covers.
4. Fasten the harness covers.
3
Rear-Facing Mode or
Only For Use in
Small Infant Positioning Pillow
When used, the small infant positioning
pillow MUST be used with the back pillow.
This pillow helps position your infant in the
seat to achieve proper harness fit.
Back Pillow
To determine if the pillow is needed:
Side View
1. Place the headrest in lowest position.
2. Place your infant in the car seat without the
pillow.
3. Make sure your infant's bottom and back
are flat against the car seat.
4. Refer to the diagrams below:
Are the Shoulder
Harness Slots
Above Shoulders?
If Yes, Use Pillow
Check often to see how much your infant has grown.
Remove the infant pillow once they can sit in the car seat without the
infant pillow and the harness slots are at or below their shoulders
AND you can still achieve a snug harness fit.
To learn how to check harness tightness, see pages 53-55.
Rear-Facing Mode
Are the Shoulder
Harness Slots
At or Below
Shoulders?
If Yes, Do Not
Use Pillow
4